Error: Mapped Logical System <LOGSYS> not Defined

Updated May 18, 2018

Hello Experts,

May I know that while configuring launch transaction for BOR based transactions, the system gives error, "Mapped Logical System <LOGSYS> not defined'.

Kindly assist, thanks in advance.

Comments

29 May 2015 6:08 pm Romil Tripathi Best Answer

Check if the logical system which you are trying to access is properly configured. The steps to configure the logical system are given below.

(a) Check in the system which you are trying to access, how the logical system is defined. This entry can be seen thru transaction SE16, table T000.

(b) In the CRM system, thru transaction SM59, create a RFC destination for the remote system.

(c) In the CRM system, thru transaction BD54, create the logical system. Make sure, that you use the same name as the logical system name of the remote system (the one you found in table T000 in step (a)).

(d) In the CRM system, thru transaction BD97, link the RFC destination created in SM59 with the logical system created in BD54.

(e) In the CRM system, thru transaction CRMS_IC_CROSS_SYS, provide the ITS URL to connect to the logical system.