Home What is SAP HR?SAP HR Training Tutorials for Beginners SAP HR Configuration Steps SAP HR-OM Infotype SAP IBAN used in R3 system SAP HR to FI Posting Configuration ABKRS vs TARIFF in SAP HR Payroll Wage Type Reporter in SAP HR SAP HR Data Migration Time Evaluation Process in SAP HR Use of BETRG and ANZHL in SAP HR Counting Rule in SAP HR PCR in SAP HR SAP HR Certification Cost in India SAP HR Interview Questions and Answers

Leave Rate Calculation (TSDIVI) During Termination

Updated May 19, 2018

Hi,

Leave rate calculation in the valuation basis is as follows

RTE= TSDIVI
DIVID ARR
Zero= A
ADDWT *

This works fine during normal run. While terminating an employee in exit mode after payroll is run, the value is TSDIVI for the next period is zero and throws an error " Division by zero not performed".

Can you please advise on this issue?

Thanks

Comments

24 Jan 2014 11:40 am Chandan Singh Parihar Helpful Answer

At initial of your PCR you can have to check that employee is active or not through "PPPAR" operation.

If employee is active, keep the same what you written previously.

If employee is not active consider the first split of WPBP through "WPALL" operation.

11 Feb 2014 5:28 am amit butola

Thank you for your inputs and quick response. It was very helpful.

11 Feb 2014 5:29 am Romil Tripathi

When the employee is not active, if the employee is not's eligible for any leave pay during the split, then the rate may need to be zero. I'd suggest checking your business requirements, then the test results of your changes