In f-44 i entered data but at the saving time it shows abap run time error.
The current application program detected a situation which really
should not occur. Therefore, a termination with a short dump was
triggered on purpose by the key word MESSAGE (type X).
What can you do?
Note down which actions and inputs caused the error.
To process the problem further, contact you SAP system
Using Transaction ST22 for ABAP Dump Analysis, you can look
at and manage termination messages, and you can also
keep them for a long time.
Short text of error message:
System error (termination point BALANCE_CCODE)
Long text of error message:
An internal error has occurred.
You cannot continue with processing.
Contact SAP to establish whether the error can only be rectified by
a program correction, or whether it can also be rectified by
changes to the settings. There may also be an error in the updating
of the data which must be resolved.
Specify the following parameters when reporting the error:
o Message : GLT0/000
o Program : SAPLGLT0
o Termination point : BALANCE_CCODE
Technical information about the message:
Message class....... "GLT0"
Variable 1.......... "BALANCE_CCODE"
Variable 2.......... "SAPLGLT0"
Variable 3.......... " "
Variable 4.......... " "